APEXi POWER FC Instruction Manual page 30

Continues from previous page
Test revision is done ........................................................................ 60
Setting mode[setting]->[Ign/Inj]
It is possible temporarily ignition timing advanced angle it can point,
retarded angle it can point, to make the fuel oil consumption increase
in quantity, to decrease the quantity. When directivity of setting is veri ed
and the like, you use.
Modify the fuel injection time when starting ......................... 62
Setting mode[setting]->[Cranking]
It is possible to set the fuel injection time that adjusts to water
temperature. When beginning kinesis is not good, when starting the
water temperature of that time it modi es fuel injection time, begins
and it is possible to improve kinesis.
Modify water temperature revision........................................... 64
Setting mode[setting]->[Wtr Temp]
When water temperature is low, because evaporation of the fuel is bad,
increasing in quantity revision is done according to water temperature.
When water temperature is low, when operability ([tsuki] and the like of
engine) is not good, it modi es the correction coe cient of water
temperature of that time, it is possible to improve the operability in warmth.
Modify Rev limit/idle rpm .............................................................. 66
Setting mode[setting]->[Rev/Idle]
Idle rpm under each conditions of the air conditioner and it is possible
to set rev limit.
30
It is possible with setting mode