It Is Possible With Setting Mode - APEXi POWER FC Instruction Manual

It is possible with setting mode

Modify the ignition timing map .................................................. 40
Setting mode[setting]->[Ign Map]
It is possible to modify the ignition timing map.
Modify the fuel revision map ........................................................42
Setting mode[setting]->[Inj Map]
It is possible to modify the fuel revision map.
When air ow metre is exchanged,
air ow rate revision of the air ow signal is done ................44
Setting mode[setting]->[Air Flow]
Air ow sensor voltage 0.64V~5.12V, it is possible to revise with
8 points of the 0.64V mark.
When the injector and burning pressure are modi ed,
injector revision is done ..................................................................50
Setting mode[setting]->[Injector]
When the injector and burning pressure are modi ed, this setting is done.
When optional [hu] ? [sutokontororukitsuto]
is installed, it modi es supercharging pressure .....................54
Setting mode[setting]->[Boost]
It is possible to set turbo charging pressure.
Modify acceleration increasing in quantity revision.............58
Setting mode[setting]->[Acceler. ]
Acceleration increasing in quantity revision adding to usual fuel injection time
according to rpm and the throttle opening change quantity, improves the
engine response. When we would like to modify acceleration increasing in
quantity which responds to rpm, this setting is done.
3rd chapter - FC commander operation summary
Continues on the nextpage
29