Adjusting Optional Sensors And Sensor Brackets - Filtec FT-50 Operation Manual

FT-50 Fill Level Inspector Operation Guide

Adjusting Optional Sensors and Sensor Brackets

2-8
After you have adjusted the head height and centerline trigger bracket
height you may need to adjust any optional sensors or sensor brackets that
are installed on the FT-50. Your Service Department should indicate
whether or not you will need to make these adjustment and what the
adjustment should be.
If your Service Department has not indicated the correct settings for the
sensors, use the procedures in this section to help you adjust the following
sensors:
Bottles
• Missing Cap, page 2-9
• High Cap, page 2-11
• Smashed Bottle, page 2-13
Cans
• Missing Lid, page 2-17
• Bulged Can, page 2-19
• Down Can, page 2-21
Industrial Dynamics Company, Ltd. Document 40272-0700