Dip Switch Settings - Elan A1240 Installation Manual

A1240
INSTALLATION MANUAL

DIP Switch Settings

The four DIP switches correspond (from top to bottom) to Bus Left, Bus Right, Direct
Input Left, and Direct Input Right. Flip the switch to the left to enable the setting, to
the right to disable it. Only one setting should be enabled (set to the left position) at
a time. Carefully review the diagrams below before setting DIP switches.
Factory Default DIP Switch Settings
BUS BUS
Direct Input-Stereo (Factory Default)
BUS BUS
Direct Input-Mono
(Sending CH. 1, 3, 5, 7, 9, or 11 to CH. 2, 4, 6, 8, 10, or 12)
BUS BUS
Direct Input-Mono
(Sending CH. 2, 4, 6, 8, 10, or 12 to CH. 1, 3, 5, 7, 9, or 11)
BUS BUS
Page 16
L
R
1
2
L
R
1
2
L
R
1
2
L
R
1
2
Bus Mode-Stereo
BUS BUS
Bus Mode-Mono
(Sending Left Bus Input to Left & Right Channels)
BUS BUS
Bus Mode-Mono
(Sending Right Bus Input to Left & Right Channels)
BUS BUS
© ELAN Home Systems 2005 • All rights reserved.
E L A N H O M E S Y S T E M S
BUS INPUT
Dipswitches
DIRECT INPUT
Dipswitches
L
R
1
2
L
R
1
2
L
R
1
2