Table of Contents
Advertisement
Transmitter Setup
To obtain the best flight performance,
we recommend using a DSM2
transmitter capable of Dual Rates. Before
binding, ensure that you are starting with a
blank acro model in your transmitter.
IMPORTANT: After you set up your model,
always rebind the transmitter and receiver
to set the desired failsafe positions.
Program Your Transmitter
1.
Start with a new ACRO Model.
2.
Set Aircraft Type: Wing >1Ail 1Flap
: Tail > Normal
3.
Leave all settings at their default
values.
The Gear Switch (ch 5) will control the Safe
mode function.
• Switch position 0 = SAFE Mode
• Switch position 1 = AS3X Mode
Dual Rates and Expos
The suggested settings shown here are the
recommended starting settings. Adjust according to
the individual preferences after the initial flight.
NOTICE: Do not set your transmitter travel adjust
over 100%. If the TRAVEL ADJUST is set over
100%, it will not result in more control movement, it
will overdrive the servo and cause damage.
It is normal for linear servos to make significant
noise. The noise is not an indication of a faulty
servo.
Tip: For the first flight, fly the model in low rate.
/DSMX
®
®
(DX6e, DX6 G2, DX7 G2, DX8 G2, DX9, DX18 and DX20)
Start all transmitter programming with a blank ACRO model
(do a model reset), then name the model.
Set Servo Travel to:
F-Mode Setup
Switch 1
Switch 2
Channel Assign
Channel Input Config
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear
6 Aux 1
Frame Rate
22mz
DSMX
Funtion List
Timer
Mode
Time
Start
Over
One Time
Computerized Transmitter Setup
100%
Inhibit
Inhibit
SAFE/AS3X
Aileron
Elevator
Rudder
Count Down
6:00
Throttle Out
25%
Inhibit
Dual Rates
Low
High
70%
100%
70%
100%
70%
100%
EN
5
Advertisement
Table of Contents
