EN
Power Components Service
Disassembly
CAUTION: DO NOT handle the propeller
while the flight battery is connected to the ESC.
Personal injury could result.
Propeller
1. Carefully remove the spinner (A) screw (B) and
propeller (C) from the motor shaft (D).
Motor
1. Remove the top cowl by pulling it up and away
from the bottom cowl.
2. Disconnect the motor wire connector from
the ESC/receiver connector.
3. Remove the screw (C) and motor (D) from
the motor mount.
4. Remove 3 screws (E) and the prop adapter (F)
from the motor. The motor magnet may attract
screws to the motor.
Assembly
Assemble in reverse order.
• Connect the motor wire connector to the ESC/
receiver.
• The propeller size numbers
(
) must face out from the motor
120MM X 70MM)
for correct propeller operation.
Landing Gear Removal
1. Carefully pull the gear straight out of the
retainer clip that secures it into the fuselage
2. Assemble in reverse order.
10
C
A
B
D
F
E
D
C