Warning And Safety Terms - Siemens SIWAREX JB Instruction Manual

Warning and Safety Terms

DANGER
Means, that death, severe injury to persons or damage to equipment will be
caused if the respective safety measures have not been taken.
WARNING
Means, that death or severe injury can be caused if the respective safety
measures are not taken.
CAUTION
With a warning triangle means that failure to take the necessary precautions may
lead to minor injury.
CAUTION
Without a warning triangle means that failure to take the necessary precautions
may lead to property damage.
IMPORTANT
Means that failure to observe the appropriate instructions may lead to an
undesirable result or condition.
NOTE
Means a note of a possible benefit if recommendations are followed.
Qualified personnel as referred to in the safety instructions in this manual and on
the product itself are individuals who are familiar with the installation, assembly,
initial start-up and operation of this product. They must be authorized and qualified
to install, start and maintain devices, systems and circuits in accordance with
national safety rules and regulations.
Copyright © Siemens AG 2006 All rights reserved
Circulation or duplication of this document, utilization and
disclosure of its contents are not permitted unless explicitly
approved. Offenders will be liable for damages. All rights reserved,
including rights created by granting of patents or registration of a
utility model or design.
Siemens AG
Automation and Drives
Process Instrumentation and Analytics
D-76181 Karlsruhe
SIWAREX JB junction box in aluminum housing – Instruction Manual
A5E00400544B
Disclaimer
We have tested the contents of this document for compatibility with
the hardware and software described. This does not exclude the
possibility of discrepancies, in which case we do not guarantee the
complete compatibility of this document. The information in this
document is assessed regularly and any necessary corrections are
included in the next revision. We are grateful for any suggestions
for improvement.
© Siemens AG 2006
Subject to technical changes
3