Buttons (In Alphabetical Order) - RCA Scenium L50000 User Manual

Chapter 3
Chapter 3
ON•OFF
DIRECTV
VCR
1
VCR
AUX
2
AUD
M1
M2
L1
L2
MUTE
CH +
VOL - VOL +
REAR
CH -
FORMAT
TEST
GUIDE
LEVEL - OK
MENU
PROGRAM
1 2
4 5
7 8
INPUT 0
FUNCTION
REV PLAY FWD
REC STOP PAUSE
CH
SWAP
CTRL
PIP
DELAY
DSP
ON•OFF
36
The Remote Control
The Remote Control

Buttons (in alphabetical order)

The buttons in blue text are audio buttons (you have to press the AUD button first
in order for them to function as described). The audio button descriptions might not
apply to your equipment.
TV
Note: It's important to remember that this section explains how these buttons
DVD
might operate if you've connected an audio component to your TV,
programmed the remote to operate that component, and your audio
M3
component supports that particular function.
L3
(Backlight button) Press and hold to enter programming mode (CODE
FRONT
SET appears in the remote's display). Press and release to illuminate the buttons (to
SKIP
conserve battery power, the light turns off after 5 seconds if you don't press any
other buttons). Pressing this button also controls the default (on/off) of the
backlight the next time you press a button.
CENTER
GO
BACK
0-9 (Number buttons) Enter channel numbers and time settings directly through
AM•FM
the remote control. For more information on entering number buttons to change
INFO
channels, go to Chapter 4 (page 73). When a menu is on the screen, you can press
LEVEL +
the number buttons to directly highlight items instead of using the arrow buttons.
CLEAR
Arrow buttons (up, down, left, right) Press the arrow buttons to move through
3
the on-screen menu system and highlight items. When the PIP window is on the
screen, press the arrow buttons to move the PIP window (but you can't move the
6
PIP window when the channel banner is on the screen — see page 76 for more
9
information).
ANT
AM • FM Selects the AM or FM band on your audio system if you've connected a
system to your TV (you must press the AUD button first to put the remote in audio
mode).
ANT Switches the source of the off-air signal between the HDTV's ANTENNA A
WHO
and B. When in VCR mode, the ANT button also functions as a TV/VCR button.
DSP
MODE
AUD Switches the remote to audio mode so the audio buttons work. Those
buttons are AM • FM, CENTER, REAR, FRONT, LEVEL + AND LEVEL -, DSP
ON•OFF, PROGRAM, FUNCTION, TEST, and DELAY.
AUX Places the remote in auxiliary mode in order to operate the component
(such as a cable box or internet device) that you've programmed to work with this
button.
Tip: Number buttons
When the menu system is on the
screen, you can press 0 to go to
the previous menu.