How To Use The Mode Mapping Feature - RCA Scenium L50000 User Manual

Chapter 3
Chapter 3
ON•OFF
DIRECTV TV
VCR
DVD
1
VCR
AUX
2
AUD
M1 M3
M2
L1 L3
L2
FRONT
MUTE SKIP
CH +
VOL - VOL +
REAR CENTER
CH -
GO
FORMAT
BACK
TEST AM•FM
GUIDE INFO
LEVEL - OK LEVEL +
MENU CLEAR
PROGRAM
1 2 3
4 5 6
7 8 9
INPUT 0 ANT
FUNCTION
REV PLAY FWD
REC STOP PAUSE
CH
SWAP
CTRL
PIP WHO
DELAY
DSP DSP
ON•OFF MODE
56
The Remote Control
The Remote Control
Discrete Clear
Use the following steps to delete a discrete code that you added.
1. Press and hold
remote's display.
2. Step through the programming menu by pressing the down arrow button until
DISCRETE CLEAR appears in the remote's display, then press the OK button.
3. Press mode button (also known as a component button) of the discrete code
that you want to clear.
4. Press the button assigned to the discrete code you want to delete (DELETED
appears).
5. To exit, press and hold the CLEAR button until EXIT SETUP appears in the
display.

How to Use the Mode Mapping Feature

The Mode Mapping feature allows you to custom map one component to another
component button. Mode Mapping is another way to program the remote control to
operate another component.
1. Press and hold
remote's display.
2. Step through the programming menu by pressing the down arrow button until
MODE MAP appears in the remote's display, then press the OK button.
3. FROM MODE appears in the remote's display prompting you to select a
component button.
4. Press the component button of your choice to apply the component to be
selected as desired.
(the backlight button) until CODE SET appears in the
(the backlight button) until CODE SET appears in the