RCA Scenium L50000 User Manual page 51

Display
window
DIRECTV ON•OFF TV
VCR
DVD
1
VCR
AUX
2
AUD
M1 M3
M2
Component
L1 L3
buttons and
L2
FRONT
MUTE SKIP
ON•OFF button
CH +
VOL - VOL +
REAR CENTER
CH -
GO
FORMAT
BACK
TEST AM•FM
GUIDE INFO
The OK
LEVEL - OK LEVEL +
button
MENU CLEAR
PROGRAM
1 2 3
4 5 6
The down
7 8 9
arrow button
INPUT 0 ANT
FUNCTION
REV PLAY FWD
REC STOP PAUSE
CH
SWAP
CTRL
PIP WHO
DELAY
DSP DSP
ON•OFF MODE
How to Stop Programming
To exit programming mode, press the CLEAR
button at any time (EXIT SETUP appears in the
remote's display to confirm that no new codes
have been entered).
Chapter 3
Chapter 3
Manual Search (MAN SRCH)
1. Make sure the component you want to program the remote control to operate
is on (let's use a VCR in this example).
2. Press the component button on the remote that corresponds to the component
you want to program the remote to operate (in this example, the VCR1 button).
Note: You can't program the TV or DIRECTV component buttons. If you want
to program this remote control to operate another TV or a satellite system,
press the AUX button (or VCR1, VCR2, DVD, AUD) and choose TV or SAT from
the list that appears in the remote's display – see step 5 below.
3. Press and hold
The backlight
remote's display window.
button
4. Press the down arrow button until you reach MAN SEARCH in the remote's
The up arrow
button
display window. Then press the OK button.
5. Press the down arrow button to scroll to the desired component (TV, VCR,
TAPE, LDP, DAT, DVD, CD, TUNER, AMP, HOME, MISC, PHONO, CAB, SAT
VIDEO). In this example, press the down arrow button until VCR appears in
the remote control's display.
6. Press the OK button (a code appears in the remote's display).
7. Press OK to send this code to the VCR. Make sure the remote is in a position
where a signal can be sent to the component. Look at the component you're
programming the remote to operate (in this example, the VCR). When the VCR
turns off, the remote has found the right code.
• If the component turns off, press OK to save the code (SUCCESS appears in
the remote's display window followed by EXIT SETUP ).
• If the component stays on, press the arrow down button to try the next
code. Press the OK button. Continue until the component turns off
(meaning the correct code has been located).
The Remote Control
The Remote Control
(the backlight button) until CODE SET appears in the
continues on next page
continues on next page
47