RCA Scenium L50000 User Manual page 53

Display
window
DIRECTV ON•OFF TV
VCR
DVD
1
VCR
AUX
2
AUD
M1 M3
M2
Component
L1 L3
buttons and
L2
FRONT
MUTE SKIP
ON•OFF button
CH +
VOL - VOL +
REAR CENTER
CH -
GO
FORMAT
BACK
TEST AM•FM
GUIDE INFO
The OK
LEVEL - OK LEVEL +
button
MENU CLEAR
PROGRAM
1 2 3
4 5 6
The down
7 8 9
arrow button
INPUT 0 ANT
FUNCTION
REV PLAY FWD
REC STOP PAUSE
CH
SWAP
CTRL
PIP WHO
DELAY
DSP DSP
ON•OFF MODE
Chapter 3
Chapter 3
3. Press and hold
remote's display window. Press the OK button.
4. Press the down arrow button to scroll to the desired component (TV, VCR,
TAPE, LDP, DAT, DVD, CD, TUNER, AMP, HOME, MISC, PHONO, CAB, SAT
VIDEO). In this example, press the down arrow button until VCR appears in
the remote control's display.
5. Use the number buttons on the remote to enter the code for your brand (the
Code List starts on page 62). Press OK.
SUCCESS appears in the remote control's display window when the code is
The backlight
correct.
button
If NOT FOUND appears in the remote control's display window, repeat step 5
The up arrow
by entering the next code from the list.
button
6. To exit, press the CLEAR button (EXIT SETUP appears and the remote is ready
to use).
7. Make sure the remote has correctly programmed the desired component (in
this example, your VCR): press the VCR button followed by the ON•OFF to
see if your VCR turns on. If the component doesn't turn on, try the following:
• Try again by repeating the previous steps listed. Make sure you're looking
in the correct section of the code list (i.e., you might have the correct
brand name, but you might be looking at the wrong type of component).
• Try programming the remote using one of the automatic code search
methods (go to page X).
• Use the Learning Feature to transfer the component's most important
functions to your LCOS TV remote control (go to page 45 or 47).
• Review the following notes.
Notes:
• This remote control cannot be programmed to operate some brands of components.
• If approximately 30 seconds passes before a button is pressed, the display window stops transmission to
conserve battery life. If this occurs, restart from step 1.
• To exit programming mode, press the CLEAR button at any time (EXIT SETUP appears in the remote's
display to confirm that no new codes have been entered).
The Remote Control
The Remote Control
(the backlight button) until CODE SET appears in the
49