Dell Recommended Switch Configuration; Hardware Configuration; Delete Startup Configuration - Dell Networking N2000 Series Manual

Switch dell networking n2000 series

Hide thumbs Also See for Networking N2000 Series:

Table of Contents

Dell recommended switch configuration

These steps show you how to configure two Dell Networking N2000 switches with a Link Aggregation

Group (LAG). The switches are interconnected using the fixed 10GbE SFP+ module on the front and the

LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).

2.1

Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using any terminal utility, open a serial connection session to the switch.

4. Open your terminal emulator and configure it to use the serial port (usually COM1, but this may

vary depending on your system). Configure serial communications for 9600,N,8,1 and no flow

control.

5. Connect the optical cables between the fixed 10GbE module on the front of the N2000 switches.

See this configuration in Figure 1.

2.2

Note: All configuration settings will be deleted

console>enable

console#reload

Are you sure you want to reload the stack? (y/n) y

Note: The switch will reboot.

Follow the prompts shown below when the Main Menu is displayed during the bootup process.

Dell Networking Boot Options

============================

Select a menu option within 3 seconds or the Operational Code will start

automatically...

1 - Start Operational Code

2 - Display Boot Menu

Select (1, 2)# 2

Boot Main Menu

==============

SCG1015

Dell Networking N2000 Series Configuration Guide

Table of Contents