Dell Recommended Switch Configuration; Hardware Configuration; Delete Startup Configuration; Disabling Data Center Bridging (Dcb) Configuration - Dell S5000 Configuration Manual

Sc series iscsi sans

Hide thumbs Also See for S5000:

Table of Contents

Dell recommended switch configuration

These steps outline how to configure two S5000 switches for use as an iSCSI SAN with SC Series storage.

2.1

Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using any terminal utility, open a serial connection session to the switch.

4. Open the terminal emulator and configure it to use the serial port (usually COM1, but this may vary

depending on the system). Configure serial communications for 9600,N,8,1 and no flow control.

2.2

Note: This example assumes a switch at its default configuration settings. Using the delete startup-

config command will set the startup configuration file to its default settings. You should always backup

your configuration settings prior to performing any configuration changes

FTOS>enable

FTOS#delete startup-config

Proceed to delete startup-config [confirm yes/no]yes

FTOS#reload

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

2.3

Note: For non-DCB environments, DCB must be manually disabled using the following steps:

FTOS>enable

FTOS#configure

FTOS(conf)#no dcb enable

FTOS(conf)#exit

FTOS#copy running-config startup-config

SCG2004

Dell Networking S5000 Switch Configuration Guide for SC Series SANs

Table of Contents