Page 1
- Besides this equipment, a complete range of other products are manufactured, consult our dealers. - Due to the constant improvements introduced to our equipments, the information contained in the PA-7LE-N present Instruction Manual may be modified without previous notice.
___________________________________________________________ 1. Introduction ___________________________________________________________ 1.1 Safety ___________________________________________________________ ___________________________________________________________ When this equipment is not correctly used it may be potentially dangerous. ___________________________________________________________ Before to use the equipment read carefully this Instruction Manual and keep it accessible ___________________________________________________________ for future consulting. To avoid accidents, injures and damages to the equipment, follow the below instructions: ___________________________________________________________ ___________________________________________________________ 1.1.1 Never use the equipment with wet clothes or wet feet, nor on a wet floor, never dip...
Page 4
7. Electric Diagram IMPORTANT Make sure the cord is in perfect working conditions , if not, change it for one in ELECTRIC NETWORK perfect conditions in accordance with the local safety norms . Such change shall be made by qualified professional. 220V / 60Hz IMPORTANT This equipment must not be used by children or any persons with reduced...
6. Maintenance 1.2 Main Components All components are made with carefully selected materials, in accordance with Siemsen Maintenance must be considered a set of procedures with the purpose to keep the experience and standard testing procedures. equipment best operating conditions, therefore increasing the equipment life and safety. * Cleaning –...
Motor thermal protection Wait some minutes and try TABLE 01 The equipment does not turned ON. again. switch ON. CHARACTERISTIC UNIT PA-7LE-N Electricity shortage. Check network. Voltage Problem with the electric circuit. Call Technical Assistance. Frequency Power Rating Height The belt is sliding.
Page 7
Check the level of oil. chayote, turnip. Do NOT insert your fingers in between belts and pulleys nor chains and gears. GRATER PLATES “V” Useed to great products (except leaves): Bread, cheese, coco nut, cashew nut. 4.6 Maintenance 4.6.1 Danger IMPORTANT Any maintenance with the machine in working situation is dangerous.
1.5 Plates coming along with the Processor and Optional Plates circuits. In the following Table 03 you will find the available Plates: The oil reservoirs have to be filled until the indicated level. Check and refill if necessary. TABLE 03 4.3 Routine Inspection 4.3.1 Advice PLATES COMING ALONG WIT THE EQUIPMENT...
been made and responded. 2 Installation and Pre Operation 4.1.3 Advices 2.1Installation * In case of power shortage, immediately switch the machine off. 2.1.1 Placing * Use recommended or equivalent lubricants, oils or greases. * Avoid mechanical shocks, once they may cause damages or bad functioning. Place the equipment on a dry, stable and level surface having a preferential 850 mm height * Avoid water, dirt or dust contact to the mechanical and electrical components of the above the floor.
2.1.2 Electric Installation 4. General Safety Practices Before to plug the equipment on the socket, make sure the voltage as it is shown on the IMPORTANT cord label, is the same network voltage. If any recommendation is not applicable to your equipment, please ignore it. The cord plug has three pin , the middle pin is for grounding.
Page 11
3.4 Cautions with Stainless Steel PICTURE 03 The Stainless Steel may present rust signs, which ARE ALWAYS CAUSED BY EXTERNAL AGENTS, especially when the cleaning or sanitization is not constant and appropriate. The Stainless Steel resistance towards corrosion is mainly due to the presence of chrome, which in contact with oxygen allows the formation of a very thin protective coat.
3. Operation IMPORTANT Always use the Stumpers in their throat , never use other tools, and principally do 3.1 Starting not use the hands. If the stumpers get lost contact your dealer to replace them. Before to start the equipment: - Make sure the Plate and the Expeller Dish are duly placed on the equipment.
Need help?
Do you have a question about the PA-7LE-N and is the answer not in the manual?
Questions and answers