DFI HD332-H81 User Manual page 38

ACPI Power Management Configuration
This section is used to configure the ACPI P ower Management.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
ACPI Power Management Confi guration
Resume by PME [Disabled]
Resume by Ring [Disabled]
[Disabled]
Resume by RTC Alarm
Wakeup Event After G3 [Disabled]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Resume by PME
Enables this field to use the PME signal to w ake up the system.
Resume by Ring
Enables this field to use the Ring signal to w ake up the system.
Resume by RTC Alarm
When Enabled, the system uses the R TC to gener ate a w akeup event.
Wakeup Event After G3
This field is used to enable or disable the specific w akeup event after G3. It needs to
switch the hardw are jumper (f or AC power on) to the proper set ting.
Chapter 3 BIOS Setup
Chapter 3
Trusted Computing
This section configures set tings relevant to Trusted Computing inno vations.
About Resume by PME
(PCI, PCIE, LAN). If
PME is enabled then PCH
After-G3 function is ena-
bled, too. But Auto Power
on function is fail.

Select Screen

Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
31
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Confi guration
Security Device Support [Disable]
Current Status Information
No Security Device Found
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Security Device Support
This field is used to enable or disable BIOS supporting f or the securit y device. O .S will
not show the securit y device. T CG EFI protocol and INT1A interf ace will not be
available.
Enables or Disables
BIOS support for security
device. O.S will not show
Security Device. TCG
EFI protocol and INT1A
interface will not be
available.

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
www.df .com