Rear Panel I/O Ports
COM 2
VGA 1
PS/2 KB/MS
USB 2.0
COM 1
VGA 2 or
DVI-I (DVI-D Signal)
The rear panel I/O ports consist of the following:
•
1 PS/2 Keyboard/Mouse port
•
2 Serial COM ports
•
2 VGA ports; or 1 VGA and 1 DVI-I ports
•
2 RJ45 LAN ports
(HD332-H81B has LAN 1 only.)
•
4 USB 3.0 ports
•
2 USB 2.0 ports
•
Line-in/Surround jack
•
Line-out jack
•
Mic-in/Center+Subwoofer jack
Chapter 2 Hardware Installation
Chapter 2
LAN 2
LAN 1
Line-in/Surround
Line-out
Mic-in/
Center+Subwoofer
USB 3.0
USB 3.0
PS/2 Keyboard/Mouse Port
PS/2 Keyboard/Mouse
COM 2
COM 1
This rear I/O port is used to connect a PS/2 mouse and a PS/2 keyboard. The PS/2 mouse
port uses IRQ12.
Wake-On-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 keyboard or PS/2
mouse to power-on the system. To use this function:
• Jumper Setting
JP15 must be set to "3-5 On: +5V_standby". Refer to "PS/2 Keyboard/Mouse Power Select" in
this chapter for more information
.
• BIOS Setting
Configure the wake-up function of PS/2 keyboard/mouse in the Advanced menu ("ACPI Power
Management Configuration" submenu) of the BIOS. Refer to the chapter 3 for more informa-
tion.
Important:
The +5V_standby power source of your power supply must support ≥720mA.
19
www.dfi .com