Audio; I/O Connectors; Sata (Serial Ata) Connectors - DFI HD332-H81 User Manual

Audio

Rear Audio
COM 2
COM 1
Line-in/Surround
Line-out
Mic-in/
Center+Subwoofer
Rear Audio
The system board is equipped with 3 audio jacks. A jack is a one-hole connecting interface for
inserting a plug.
• Line-in/Surround Jack (Light Blue)
This jack is used to connect any audio devices such as Hi-fi set, CD player, tape player,
AM/FM radio tuner, synthesizer, etc.
• Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
• Mic-in/Center+Subwoofer Jack (Pink)
This jack is used to connect an external microphone.
Driver Installation
Install the audio driver. Refer to the chapter 4 for more information.
Chapter 2 Hardware Installation
Chapter 2

I/O Connectors

SATA (Serial ATA) Connectors

COM 2
COM 1
Features
• 4 Serial ATA connectors
- 2 SATA 3.0 ports with data transfer rate up to 6Gb/s (SATA 0 and SATA 1)
- 2 SATA 2.0 ports with data transfer rate up to 3Gb/s (SATA 4 and SATA 5)
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu ("SATA Configuration" submenu) of the
BIOS. Refer to the chapter 3 for more information.
Note:
Some 3rd party SATA Gen 2 speed device controllers used on the system board paired
with the Intel 8 series chipset are intermittently detected. Before using SSD devices
®
or mSATA SSD devices, please check whether the device and the cable which are
used on the system board conform to Intel's official regulations.
23
7 1
SATA 0
SATA 1
SATA 3.0 6Gb/s
(SATA port 1 provides adequate
space for SATA DOM)
SATA 2.0 3Gb/s
1
7
SATA 5 SATA 4
www.dfi .com