Yaesu FTDX3000 Technical Supplement page 3

Receiver
Circuit Type:
Intermediate Frequencies:
Sensitivity:
Selectivity (WIDTH: Center):
Image Rejection:
Maximum Audio Output:
Audio Output Impedance:
Conducted Radiation:
Specifications are subject to change, in the interest of technical improvement, without notice or obligation,
and are guaranteed only within the amateur bands.
Double-conversion Superheterodyne
9.000 MHz/30 kHz (24 kHz for AM/FM)
SSB (BW: 2.4 kHz, 10 dB S+N/N)
4 µV (0.5 - 1.8 MHz) (IPO "ON")
0.16 µV (1.8 - 30 MHz) (RF AMP 2 "ON")
0.125 µV (50 - 54 MHz) (RF AMP 2 "ON")
AM (BW: 6 kHz, 10 dB S+N/N, 30 % modulation @400 Hz)
28 µV (0.5 - 1.8 MHz) (IPO "ON")
2 µV (1.8 - 30 MHz) (RF AMP 2 "ON")
1 µV (50 - 54 MHz) (RF AMP 2 "ON")
FM (BW: 15 kHz, 12 dB SINAD)
0.5 µV (28 - 30 MHz) (RF AMP 2 "ON")
0.35 µV (50 - 54 MHz) (RF AMP 2 "ON")
There is no specification for frequency ranges not listed.
Mode
CW/RTTY/PKT
SSB
AM
FM
70 dB or better (1.8 MHz - 30 MHz Amateur bands)
60 dB or better (50 MHz - 54 MHz Amateur band)
2.5 W into 4 Ohms with 10% THD
4 to 8 Ohms (4 Ohms: nominal)
Less than 4 nW
SPECIFICATIONS-3
–6 dB
0.5 kHz or better
2.4 kHz or better
6 kHz or better
15 kHz or better
FT
Specifications
–60 dB
750 Hz or less
3.6 kHz or less
15 kHz or less
25 kHz or less
3000 Technical Supplement
DX