Yamaha AG200FZ Owner's Manual page 69

2. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
4
5
3
2
1
1. Wheel axle
2. Drive chain slack adjusting plate
3. Brake camshaft lever
4. Brake pedal free play adjusting nut
5. Brake rod
3. Loosen the axle nut and the rear
sprocket nut.
PERIODIC MAINTENANCE AND ADJUSTMENT
2
1
3
1. Axle nut
2. Rear sprocket nut
3. Drive chain slack adjusting plate
4. Lift the rear wheel off the ground
according to the procedure on
page 7-32.
5. Turn the drive chain adjusting
plate on each side of the swingarm
fully in direction (a).
6. Remove the axle nut.
7. Pull the wheel axle out together
with the drive chain adjusting plate
from the right-hand side.
8. Slide the wheel to the right, and
then remove it by pulling it back.
7-35
To install the rear wheel
1. Install the drive chain adjusting
plate and the wheel by inserting
(a)
the wheel axle from the right-hand
side.
TIP
Make sure that the drive chain adjust-
ing plate is installed with the punched
side facing to the outside.
2. Install the axle nut.
3. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
4. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and the nut, and then tight-
en the nut to the specified torque.
Tightening torque:
Brake torque rod nut:
19 Nm (1.9 m·kgf, 14 ft·lbf)
5. Insert
WARNING! Always use a new
cotter pin.
6. Adjust the drive chain slack. (See
page 7-22.)
EAU49030
a new cotter pin.
[EWA10831]
2
3
4
5
6
7
8
9