Yamaha AG200FZ Owner's Manual page 45

7. Check the O-rings for damage and
replace them if necessary.
8. Clean the oil filter element with sol-
vent, and then install it.
TIP
Check the oil filter element for damage
and replace it if necessary.
9. Install the oil filter element cover by
installing the bolts and the drain
bolt, then tightening them to the
specified torques.
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Make sure that the O-rings are properly
seated.
10. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
11. Install the oil strainer, compression
spring, a new O-ring and engine oil
drain bolt, and then tighten the
drain bolt to the specified torque.
PERIODIC MAINTENANCE AND ADJUSTMENT
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
12. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter element removal:
1.00 L (1.06 US qt, 0.88 Imp.qt)
With oil filter element removal:
1.10 L (1.16 US qt, 0.97 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
7-11
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11620
2
3
4
5
6
7
8
9