Supermicro SUPERSERVER 5018A-LTN4 User Manual page 87

Table of Contents

Chapter 7: BIOS

Pass Gate Stress Test Conﬁ guration

Pass Gate Test

Select Enabled to use the Pass Gate test. The options are Disabled and

Enabled.

Pass Gate Test Direction

This feature speciﬁ es how the BIOS setup utility should perform the Pass Gate

test (from the lowest memory to the highest or from the highest memory to the

lowest.) The options are Lowest to Highest and Highest to Lowest.

Pass Gate Test Repetition

Use this feature to specify how many times the Pass Gate test should be

performed over the same memory row (x1000). The default setting is 900.

Pass Gate Test Iterations

Use this feature to specify how many repetitions the Pass Gate test should be

performed over the same memory row (refer to the item above). The default

setting is 1.

Pass Gate Test Swizzle (For Samsung Products)

Select Enabled to use the Pass Gate Test Swizzle mode to support Samsung

products. Select Auto for the system to automatically switch to the Pass Gate

Test Swizzle mode when a Samsung device is detected. The options are Auto

and Enabled.

Pass Gate Pattern

Use the keyboard to enter the parameter value of the Pass Gate Pattern used

for data input. The options are 0's and 1's.

Pass Gate Target Pattern

Use the keyboard to enter the target parameter value for the Pass Gate Pattern

used for data input. The options are 0's and 1's.

Pass Gate Speed

Use this feature to set the Pass Gate speed. The options are Auto and 1x Only.

Channel 0/Channel 1

Rank 0/Rank 1/Rank 2/Rank 3

Select Enabled to allow the Pass Gate test to be performed on a memory module

speciﬁ ed by the user. The options are Enabled and Disabled.

7-11

Table of Contents