Removable Cooktop Burners - Roper F8858W0 Use And Care Manual

REMOVABLE COOKTOP BURNERS
The cooktop burners on your range may be removed for
cleaning. Be sure all cooktop knobs are turned to off and
burners are cool, then remove or raise the cooktop.
Your range has two types of burners One type of burner has
a solid top and IS used at the two rear cooktop positions and
at the left front cooktop position of some models.
The second type of burner IS cone-shaped and has a circular
opening through the center of the burner bead. This All-
Purpose burner is used at the right front cooktop posltlon or
at both front cooktop posttlons of some models.
Do not try to use the burners In any other posItIon. Damage
to your range may result If the smaller burners are used in
the All-Purpose burner positlons.
If shipping screws were not removed from the burner
when the range was installed, do so now (see your Installa-
tion Guide for Instructions). These screws may be
discarded.
To Remove Burners:
1. Grasp the burner head and tilt it to the right to release
the two tabs from the burner support (A in Fig. A).
BURNER
I
'I
SHUTTER
TAB
Fig. A
2. Lift the end of the burner assembly, then pull away from
the front of the range to free the air shutter from the gas
valve orifice (B in Fig. A).
Check lighler and burner ports (Fig. B). If they are clogged,
use a wire or needle to clear them.
See the Cleaning instructions on page 17. Becareful not to
disturb the air shutter setting while cleaning. If you need to
readjust the air shutter, see your Installation Guide.
To Replace Burners:
1. Slip the air shutter over the gas valve orifice (Fig. A).
2. Lower the burner assembly and hook the tab in the slots
in the burner support (Fig. A).
3. Be sure both tabs are in their slots, that the burner sits
level and straight and that the flash tube forms a straight
line from the igniter to the burner (Fig. B).
19
BURNER
Fig. B
IGNITER