Lift Up/Off Cooktop - Roper F8858W0 Use And Care Manual

REPLACING PANEL LIGHT
Do
not touch
the bulb when it is hot or with wet hands.
Never wipe light area with a wel cloth. Interrupt electrical
supply before removing.
To Replace Bulb:
1 Remove c,anopy by pulhny it up and off the backguard.
2 Remove Sulb Replace the bulb with one of the same
length and wattage
3 Reolace canopy.
To Replace Starter:
1 Remove canopy and bulb as explained above
2 Grasp starter, turn it counterclockwlse, about one
quarter turn and hfl out. Replace with one of the same
wattage
3 Reoosltlon bulb and canopy.
CANOiY
I
BULB
18
LIFT UP/OFF COOKTOP
ihe cooktop can be ralsea or removed so the area under it
can be cleaned.
To Raise Cooktop:
1. Remove the burner grates
2 Raise the front of the cooktop unit until the support rods
snap Into posltlon to hold cooktop.
3 When finished. carefully lower cooktop into place while
pushing In on the front of the support rods.
To
Remove Cooktop:
1. Remove the burner grates
2. Grasp the cooktop and lift the front a little.
3 Grasping the cooktop at the sides, hold it nearly
flat
while you lift it up and off the back hinges. Unhook the
bottoms of the support rods from the range.
See the cleaning instructions on page 17. When finished
cleaning, carefully lower cooktop into place, pushing in on
the front of the support rods
HOLD FLAT TO REMOVE
SUPPORT RODS