User Guide Introduction This evaluation board is designed to help the customer evaluate the 9FGV1006 device. When the board is connected to a PC running IDT Timing Commander™ Software through USB, the device can be configured and programmed to generate different combinations of frequencies.
Page 2
Alternative I C interface connector for Aardvark. C interface Connector IDT Timing Commander can also use Aardvark. Connect this USB to your PC to run IDT Timing Commander. USB Connector The board can be powered from the USB port. Connect to 1.8V, 2.5V or 3.3V for the output voltage of Output Power Supply Jack the device.
Page 3
Miscellaneous interfaces can connect to J2 pin 1 for the Serial Clock and to J2 pin 3 for the Serial Data signal. J2 pin 2 can be used as ground, but any other ground pin will also work. When OTP in the 9FGV1006 device is burned with multiple configurations, JP1 and JP2 can be applied in JP3 position respectively. Connect JP3 (SEL_I2C#) to V and power-up the 9FGV1006 in Hardware Select mode.
IDT or any third parties. IDT's products are not intended for use in applications involving extreme environmental conditions or in life support systems or similar devices where the failure or malfunction of an IDT product can be rea- sonably expected to significantly affect the health or safety of users.