Dell iDRAC7 User Manual page 95

• CPU — Indicates the health and state of the CPUs in the managed system. It also reports processor automatic
throttling and predictive failure.
• Memory — Indicates the health and state of the Dual In-line Memory Modules (DIMMs) present in the managed
system.
• Intrusion— Provides information about the chassis.
• Power Supplies (available only for rack and tower servers) — Provides information about the power supplies and
the power supply redundancy status.
NOTE: If there is only one power supply in the system, the power supply redundancy is set to Disabled.
• Removable Flash Media — Provides information about the Internal SD Modules—vFlash and Internal Dual SD
Module (IDSDM).
– When IDSDM redundancy is enabled, the following IDSDM sensor status is displayed—IDSDM Redundancy
Status, IDSDM SD1, IDSDM SD2. When redundancy is disabled, only IDSDM SD1 is displayed.
– If IDSDM redundancy is initially disabled when the system is powered on or after an iDRAC reset, the IDSDM
SD1 sensor status is displayed only after a card is inserted.
– If IDSDM redundancy is enabled with two SD cards present in the IDSDM, and the status of one SD card is
online while the status of the other card is offline . A system reboot is required to restore redundancy between
the two SD cards in the IDSDM. After the redundancy is restored, the status of both the SD cards in the IDSDM
online .
is
– During the rebuilding operation to restore redundancy between two SD cards present in the IDSDM, the IDSDM
status is not displayed since the IDSDM sensors are powered off.
– System Event Logs (SEL) for a write-protected or corrupt SD card in the IDSDM module are not repeated until
they are cleared by replacing the SD card with a writable or good SD card, respectively.
• Temperature — Provides information about the system board inlet temperature and exhaust temperature (only
applies to racks and towers). The temperature probe indicates whether the status of the probe is within the pre-set
warning and critical threshold value.
• Voltage — Indicates the status and reading of the voltage sensors on various system components.
The following table provides how to view the sensor information using iDRAC7 Web interface and RACADM. For
information about the properties that are displayed on the Web interface, see the
pages.
Table 10. Sensor Information Using Web Interface and RACADM
View Sensor Information For
Batteries
Fan
CPU
Memory
Intrusion
Power Supplies
Removable Flash Media
Using Web Interface
Overview → Hardware → Batteries
Overview → Hardware → Fans
Overview → Hardware → CPU
Overview → Hardware → Memory
Overview → Server → Intrusion
Overview → Hardware → Power
Supplies
Overview → Hardware → Removable
Flash Media
iDRAC7 Online Help for the respective
Using RACADM
Use the getsensorinfo command.
For power supplies, you can also use
the System.Power.Supply command
with the get subcommand.
For more information, see the
RACADM Command Line Reference
Guide for iDRAC7 and CMC available
at dell.com/support/manuals.
95