Miscellaneous - Dell iDRAC7 User Manual

This occurs because the create partition operation is in-progress. However, the partition is deleted after sometime and a
message that the partition is deleted is displayed. If not, wait until the create partition operation is completed and then
delete the partition.

Miscellaneous

How to find an iDRAC IP address for a blade server?
You can find the iDRAC IP address using any of the following methods:
Using CMC Web interface: Go to Chassis → Servers → Setup → Deploy. and in the displayed table, view the IP address
for the server.
Using the Virtual Console: Reboot the server to view the iDRAC IP address during POST. Select the "Dell CMC" console in
the OSCAR to log in to CMC through a local serial connection. CMC RACADM commands can be sent from this
RACADM Command Line Reference Guide for iDRAC7 and CMC for a complete list of CMC RACADM
connection. See the
subcommands.
From local RACADM, Use the command: racadm getsysinfo For example:
$ racadm getniccfg -m server-1
DHCP Enabled
IP Address
Subnet Mask
Gateway
Using LCD: On the Main Menu, highlight the Server and press the check button and select the required server and press
the check button.
How to find the CMC IP address related to the blade server?
From iDRAC7 Web interface: Click Overview → iDRAC Settings → CMC . The CMC Summary page displays the CMC IP
address.
From the Virtual Console: Select the "Dell CMC" console in the OSCAR to log in to CMC through a local serial connection.
CMC RACADM commands can be issued from this connection. See the
iDRAC7 and CMC for a complete list of CMC RACADM subcommands
$ racadm getniccfg -m chassis
NIC Enabled
DHCP Enabled
Static IP Address
Static Subnet Mask
Static Gateway
Current IP Address
Current Subnet Mask = 255.255.255.0
Current Gateway
Speed
Duplex
NOTE: You can also perform this using remote RACADM.
How to find iDRAC IP address for rack and tower server?
From iDRAC7 Web Interface: Go to Overview → Server → Properties → Summary . The System Summary page displays
the iDRAC7 IP address.
From Local RACADM: Use the command racadm getsysinfo.
From LCD: On the physical server, use the LCD panel navigation buttons to view the iDRAC7 IP address. Go to Setup
View → View → iDRAC IP → IPv4 or IPv6 → IP.
From OpenManage Server Administrator: In the Server Administrator Web interface, go to Modular Enclosure →
System/Server Module → Main System Chassis/Main System → Remote Access.
246
= 1
= 192.168.0.1
= 255.255.255.0
= 192.168.0.1
= 1
= 1
= 192.168.0.120
= 255.255.255.0
= 192.168.0.1
= 10.35.155.151
= 10.35.155.1
= Autonegotiate
= Autonegotiate
RACADM Command Line Reference Guide for