Enabling Or Disabling Os To Idrac Pass-Through - Dell iDRAC7 User Manual

For more information, see the
manuals.
4. Enable the Auto Shutdown and Recovery (ASR) option using one of the following:
– Server Administrator — See
– Local RACADM — Use the command:
racadm config -g cfgRacTuning -o cfgRacTuneAsrEnable 1
5. Enable Automated System Recovery Agent. To do this, go to Overview → iDRAC Settings → Network → Services,
select Enabled and click Apply.

Enabling or Disabling OS to iDRAC Pass-through

In servers that have Network Daughter Card (NDC) or embedded LAN On Motherboard (LOM) devices, you can enable
the OS to iDRAC Pass-through feature that provides a high-speed bi-directional in-band communication between
iDRAC7 and the host operating system through a shared LOM (rack or tower servers), a dedicated NIC (rack, tower, or
blade servers), or through the USB NIC. This feature is available for iDRAC7 Enterprise license.
When enabled through dedicated NIC, you can launch the browser in the host operating system and then access the
iDRAC Web interface. The dedicated NIC for the blade servers is through the Chassis Management Controller.
Switching between dedicated NIC or shared LOM does not require a reboot or reset of the host operating system or
iDRAC.
You can enable this channel using:
• iDRAC Web interface
• RACADM or WS-MAN (post operating system environment)
• iDRAC Settings utility (pre-operating system environment)
If the network configuration is changed through iDRAC Web interface, you must wait for at least 10 seconds before
enabling OS to iDRAC Pass-through.
If you are using the XML configuration file through RACADM or WS-MAN and if the network settings are changed in this
file, then you must wait for 15 seconds to either enable OS to iDRAC Pass-through feature or set the OS Host IP address.
Before enabling OS to iDRAC Pass-through, make sure that:
• iDRAC is configured to use dedicated NIC or shared mode (that is, NIC selection is assigned to one of the LOMs).
• Host operating system and iDRAC7 are in the same subnet and same VLAN.
• Host operating system IP address is configured.
• A card that supports OS to iDRAC pass-through capability is installed.
• You have Configure privilege.
When you enable this feature:
• In shared mode, the host operating system's IP address is used.
• In dedicated mode, you must provide a valid IP address of the host operating system. If more than one LOM is active,
enter the first LOM's IP address.
After enabling OS to iDRAC Pass-through feature, if it is not working:
• Check whether the iDRAC's dedicated NIC cable is connected properly.
• Make sure that at least one LOM is active.
Related Links
Supported Cards for OS to iDRAC Pass-through
Dell OpenManage Server Administrator Installation Guide at dell.com/support/
Dell OpenManage Server Administrator User's Guide at dell.com/support/manuals.
79