7.
Pull the end side (top) of the Velcro strap to eliminate the slack over the cable
connector.
Figure 5-20: Pulling Velcro Strap to Reduce Slack over Cable
8.
Feed the end side of the strap through the strap's buckle.
Figure 5-21: Feeding Velcro Strap through Strap Buckle
9.
Pull the end side of the Velcro strap to eliminate all slack in the strap, and then pull up
on the strap and press it firmly on the area of the strap that is already wound around
the cable connector so that the strap attaches firmly to itself.
Follow the instructions described in this document to connect AudioCodes Mini Patch Panel
to the MP-124, and to the analog FXS lines.
To protect against electrical shock and fire, use 26 AWG minimum wire cabling to
Hardware Installation Manual
Figure 5-22: Attaching Velcro Strap to Itself
MP-124 Safety Notice:
connect the Mini Patch Panel and to connect the analog FXS lines.
36
MP-124
Document #: LTRT-59847