Exercise/Hts - Generac Power Systems H-100 Technical Manual

Press the "ENTER" button.
Press the "ENTER" button.
The above two pages are typical of communications
diagnostics, one page for each port. The LCD display
will show four lines of information about the port:
LINE 1: Will show the type of port protocol that has
been selected. It will also show the Modbus address
(if appropriate) and whether the port is RS-232 or
RS-485.
LINE 2: Will show the settings for the port such as
baud rate, bits per character, stop bits, and parity.
LINE 3: Shows a live update of counts of messages
transmitted, received, and errors.
LINE 4: Shows a mimic of LED's for TX, RX, and
ERR. For example, the TX LED lit (T*) means the H-
100 Control Panel is transmitting. Not lit (T-) means
it is not transmitting.

EXERCISE/HTS

There are four pages under this menu item – two for
internal exercise and two for HTS. This is where the
internal exercise can be setup and enabled (see the
Exercise Setup Using Front Panel section) and the
HTSs can be enabled and monitored.
Do the following to view the internal exercise and
HTS pages:
Press the "MENU" button.
General Information
H-100 Control Panel Technical Manual
Press the  button.
Press the "ENTER" button.
This is a typical first Internal Exercise and HTS
page.
LINE 1: Indicates if internal exercise is enabled. This
field is editable.
LINE 2: Day of week and time of day to start the
exercise weekly. These fields are editable.
LINE 3: How much time remains before exercise is
completed. It starts with 20 minutes.
LINE 4: The "More" field to allow page selection.
Press the "ENTER" button.
This is a typical second Internal Exercise and HTS
page.
LINE 1: Indicates if QuietTest® is enabled. This field
is editable.
LINE 2: Can be used to start a 20 minute exercise
period right now. This field is editable.
LINE 3: Indicates if the HTS switches should be
exercised during normal exercise mode. This field is
editable.
LINE 4: The "More" field to allow page selection.
Press the "ENTER" button.
21