Available Actions - Agilent Technologies 7697A Advanced Operation Manual

Available actions

Advanced Operation
Enter the acceptable vial leak rate. The default is 2 mL/min.
Dyn leak test action: Available only when leak detection is
enabled. Enter which action to take if a vial fails the
dynamic leak test.
In addition, if using a barcode reader additional sequence
actions are available. However, note that data systems
typically override any barcode reader actions set in the
method.
Barcode mismatch: Control HS behavior if the barcode value
does not match the expected value.
BCR read err action: Control HS behavior if the barcode reader
encounters an error while reading the barcode.
BCR invalid checksum: If using a symbology that uses checksum
values, select what to do when the checksum does not match
the value read from the label.
The actions available for each issue depend on the nature of
the sequence issue. (For example, you cannot continue to
process a missing vial, but you can skip the vial or abort the
sequence.)
• Continue: Continue processing the current sample vial and
the sequence.
• Skip: Skip the current sample vial, then continue
processing with the next sample vial in the sequence. The
current sample vial is immediately returned to the tray, if
appropriate. The system skips all injections for that vial.
• Pause: Pause the sequence. Any vials in the oven will
continue to be processed, including the current vial, if
applicable. For HS models with a 111 vial tray, no other
vials will be moved into the vial oven. For the 12 vial
model, the HS processes the current vial, then stops.
• To recover from a pause (111 vial model): Place
missing vial or correct size vial on the shutter. Remove
incorrect vial from the tray, if present. Press [Start] on
the HS keypad.
• To recover from a pause (12 vial model): The vial
was run if present. If missing, place correct vial into
the carousel location. Press [Start] on the HS keypad.
3
Method Development
53