Microsemi SyncServer S300 User Manual page 108

Command Line Interface
0
For example, one satellite with vehicle number 16:
1,16,C,-158
For six satellites:
6,12,C,-156,14,C,-155,8,T,-162,24,C,-158,18,C,161,6,C,-160
HALT: Halts the operating system. After entering the command, it prompts "Enter 'Y' to con-
firm". Halt the SyncServer before turning the power off. Action only command.
REBOOT: Halts and reboots the operating system. After entering the command, it prompts
you . Enter "Y" to confirm. Action only command.
DEFAULTS: Replaces the current configuration of the SyncServer with the factory default con-
figuration. After entering the command, it prompts 'Enter "Y" to confirm'. The command also
halts and reboots the SyncServer. Action only command.
IPV4ADDRESS <aaa.bbb.ccc.ddd>: Displays or sets the LAN1 IPv4 address. Without input, the
command displays the current IPv4 address. With input, the command sets the new IPv4
address. Query and action command.
IPV4MASK <aaa.bbb.ccc.ddd>: Displays or sets the LAN1 IPv4 subnet mask. Without input, the
command displays the current IPv4 subnet mask. With input, the command sets the new
IPv4 subnet mask. Query and action command.
IPV4GATEWAY <aaa.bbb.ccc.ddd>: Displays or sets the LAN1 IPv4 gateway. Without input, the
command displays the current IPv4 gateway. With input, the command sets the new IPv4
gateway. Query and action command.
IPV4DHCP: Enables DHCP for LAN1. Action only command.
IPV6AUTO: Enables the automatically generated IPv6 link local address for LAN1. Action only
command.
HTTP <on|off>: Without input, the command returns the current status of the SyncServer http
daemon (running or stopped). Use input "on" or "off" to start or stop the SyncServer http dae-
mon. Query and action command.
NTP_QUERY <enable|disable>: Without input, the command returns the current configuration
status of the monlist query response (enabled or disabled). Use input "enable" or "disable" to
start or stop response to monlist query. Query and action command.
SETTIMEOFYEAR <time>: Sets the current time in UTC. The <time> input format can be any
one of the following
mm/dd/yyyy hh:mm:ss.x
yyyy ddd hh:mm:ss.x
mm dd yyyy hh:mm:ss.x
hh:mm:ss.x
Enter the command without any input, it displays the allowable input time format. Action only
command.
ADJUSTTIMEOFYEAR <seconds>: Adjust the current time by a user determined number of
seconds. The input can be a positive or a negative integer. If the input is negative, the time is
adjusted backward. Action only command.
Page 108..........................................................................997-01520-02 Rev. F1