Force Reverse; Enable/Disable Audio Alarm; Select System (Optional Feature W/ 863A Expansion Board) - Autopilot Pool Pilot Digital Nano+ Owner's Manual

Page 26
3) Press
SELECT.
4) Press

7.6.12 Force Reverse

Note: This is a diagnostic tool only, and should not be used unless a problem is suspected.
Program the cell to activate a Force Reverse cycle and verify if the system is reversing polarity
(self-cleaning). There will be a 40 second delay, after selecting "End menu mode", before
reversing takes place.
1) Press MENU, press
SELECT.
2) Press
3) "Cell reversing" will display temporarily in 40 seconds.
4) Press
5) The "." (period) on the end of 2nd line of the display will either appear, or disappear—
based on its previous state—to indicate cell power polarity has reversed.

7.6.13 Enable/Disable Audio Alarm

Note: If alarm is due to low or no water flow, the Audio Alarm will automatically silence in
10 minutes. Upon restoration of flow, normal Audio Alarm operation will resume.
1) Press MENU, press
displayed; then press SELECT.
2) Press
3) Press
4) Press

7.6.14 Select System (Optional Feature w/ 863A Expansion Board)

Used by the installer to set the basic equipment configuration of the system.
1) Press MENU, press
SELECT for 13 seconds.
2) Press
factory setting). The display will show the current configuration.
3) Press
4) Press
If the optional 863A Expansion Board has been installed, additional options will be displayed
that are not supported with this model. Do not choose "pH Timed", "pH Probe" or "Total
Control":
or until the desired cycle time (2, 4, 8, or 16 hours) is displayed; then press
until "End menu mode" is displayed; then press SELECT.
or
until "Maintenance menu" is displayed; then press
or
until "Force reverse" is displayed; then press SELECT.
or
until "End menu mode" is displayed; then press SELECT.
or
until "Owner options" or "Installer menu" is
or
until "Audio alarm" is displayed; then press SELECT.
or
until "On or off" is displayed; then press SELECT.
or
until "End menu mode" is displayed; then press SELECT.
or
until "Installer menu" is displayed, then press and hold
or
until "Select system" is displayed, then press SELECT (Purifier is the
or
until "Purifier" is displayed, then press SELECT.
or
until "End menu mode" is displayed; then press SELECT.
or