Select Units; Set Temperature Unit; Display Temperature; Set 12/24 Hour Clock (Optional Feature W/ 863A Expansion Board) - Autopilot Pool Pilot Digital Nano+ Owner's Manual

Page 24

7.6.5 Select Units

Used to program the operator's personal preferences for the liquid and weight measurements
the Digital Nano/Nano+ will display.
1) Press MENU, press
displayed; then press SELECT.
2) Press
units" is the factory setting).
3) Press
"Metric units" (liters and kilograms), is displayed; then press SELECT.
4) Press

7.6.6 Set Temperature Unit

Set personal preference for temperature display units (°C or °F).
1) Press MENU, press
displayed; then press SELECT.
2) Press
("Fahrenheit" is the factory setting).
3) Press
displayed; then press SELECT.
4) Press

7.6.7 Display Temperature

Choose to either show or hide the water temperature on the normal display screen.
1) Press MENU, press
SELECT (approximately 13 seconds) until "Installer menu" is displayed again and
is accessible.
2) Press
temperature" is the factory setting.)
3) Press
choose desired option and then press SELECT.
4) Press
Note: Even if the Display Temp feature is turned off, the temperature can be viewed in
the "Test Pool Pilot" menu for diagnostic purposes.

7.6.8 Set 12/24 Hour Clock (Optional Feature w/ 863A Expansion Board)

Set personal preference for time clock display.
1) Press MENU, press
displayed, then press SELECT.
2) Press
the factory setting).
3) Press
press SELECT.
4) Press
until "Owner options" or "Installer menu" is
or
until "Select units" is displayed; then press SELECT ("English
or
until desired measurement "English units" (gallons and pounds), or
or
until "End menu mode" is displayed; then press SELECT.
or
until "Owner options" or "Installer menu" is
or
until "Temperature unit" is displayed; then press SELECT
or
until desired measurement unit "Fahrenheit" or "Celsius" is
or
until "End menu mode" is displayed; then press SELECT.
or
until "Installer menu" is displayed; then press and hold
or
until "Display temp" is displayed; then press SELECT. ("Show
or
until "Show temperature" or "Hide temperature" is displayed;
or
until "End menu mode" is displayed; then press SELECT.
or
until "Owner options" or "Installer Menu" is
or
until "12/24 hour clock" is displayed, then press SELECT (12 hour is
or
until desired time format "12 hour" or "24 hour" is displayed, then
or
until "End menu mode" is displayed then press SELECT.
or