ETC Net3 Conductor Setup Manual page 4

ETC Setup Guide
Step 1:
Note:
Step 2:
Note:
Display
The backlit display cycles through the following screens in two second intervals:
ETC NET3 CONDUCTOR
Screen 1
v#.#.#.#.#.##
Day Month Year hour:min
Screen 2
Time zone +- offset , DST
10.101.50.60
Screen 3
UP Days hours min sec
Firmware Update
When updating firmware to the Net3 Conductor, the display will show progress of the firmware
retrieval and the installation.
Web Interface
Net3 Conductor is provided with a built-in web interface, accessible only through the use of a web
browser. The web interface allows for:
• access to view and set the network IP and mode
• access to set up a secondary network connection as well as SMTP server settings
• ability to configure Windows File Sharing
• access to set and monitor the services provided over the network; such as DNS server, NTP
time server, File Sharing access, and the DHCP server
• ability to configure logging features, including saving and clearing data and setup of log
backup destinations
• ability to generate a backup of the current configuration and upload a configuration
• ability to upgrade Net3 Conductor software
• ability to reboot, shutdown, or restore the factory defaults to the Net3 Conductor
• ability to set up email alerts, set up rules, and post HTTP actions for system error events
Step 1:
Step 2:
Step 3:
For further configuration information, reference the Net3 Conductor built-in help system by
clicking on the "Help" tab at the left side of the web interface screen.
Net3 Conductor Setup Guide
Apply power to the unit. On the initial power up, the Net3 Conductor unit will
remain powered off until the power switch is activated.
In case of a power loss, the Net3 Conductor restores to the previous power state
when power is restored.
Press the power button located on the front panel to power up. The power indicator
will illuminate in blue when the unit is powered on and the display will begin cycling
through the available status screens.
• During the power up and shut down cycles, the power indicator flashes.
During a firmware update, the power LED will flash progressively. When the
update is complete, the power LED returns to a solid state.
To view this web interface, physically connect and configure a computer to the same
network as the Net3 Conductor.
Launch the desired web browser (Internet Explorer 7 or newer, Firefox, etc).
Enter the Net3 Conductor IP address in the address line of the web browser. The
factory default IP address is 10.101.50.60.
displays the full software version number
currenet date and time honors 12/24 hour preference setting
DST displays after the time zone offset when enabled
displays Network adapter IP address
total uptime for the unit.
Page 4 of 4
Net3 Conductor
Electronic Theatre Controls, Inc.