ETC Net3 Conductor Setup Manual page 3

ETC Setup Guide
Connect
Complete the Net3 Conductor unit connections as defined below:
DC Power Input
• 12Vdc, 5A max
* Unlabeled connections are not used.
Step 1:
Step 2:
Step 3:
Note:
Initial Power Up and Status
Display
• cycles information related to the
Net3 Conductor and the network
USB 2.0
The power button and LED on the front of the unit provides information about the power state
of the device. During normal operation, the indicator remains lit.
Net3 Conductor Setup Guide
Connect an Ethernet cable (not provided) between the ETC Net3 Ethernet network
and the Net3 Network interface connector on the unit.
Plug the provided DC power input cable into the power input receptacle on the rear
panel of the unit and tighten the locking ring for a secure connection.
• An regional specific power supply kit has been provided. For EU regions, select
the appropriate connector from the power supply kit and assemble the cable to
the power supply then connect to the power source. Tie back the power supply
in the rack, taking care to ensure the power supply is supported independently
of the power connections.
When using an external network (external of the ETC lighting network) to access the
Net3 Conductor for SMS and e-mail messaging of log reports and error data, connect
the external network to the Secondary Network interface connector on the unit.
Do not connect the Net3 Conductor directly to the Internet without an
appropriate firewall or network address translation system in place. When
working in a corporate environment or building network system, consult your
network system administrator for assistance in setting up a secured connection.
NET3 Network input
• 10/100 Mbps
• Auto-sensing
• RJ45 compatible
-D
Power button
• Press and release to power up or shut down
• Solid LED indicates power on
Page 3 of 4
Net3 Conductor
Secondary Network
• External Time Synch
• 10/100 Mbps
• Auto-sensing
• RJ45 compatible
Electronic Theatre Controls, Inc.