Registering A New Handset - Samsung SP-R6100 Service Manual

2-9-2 Registering a New Handset

The handset supplied with the base unit is already registered as handset 1. Each additional handset you
purchase must be registered to the base unit.
1. Press and hold the Paging key on the base for more than 3 seconds. The light is blinking.
2. Press the Menu soft key on the handset.
3. Press the soft key repeatedly until System appears, then press the Select soft key. You are asked to enter
the PIN code. It is preset to 0000.
4. Enter the PIN code, then press the OK soft key.
5. Press the soft key repeatedly until Registration appears.
6. Press the Select soft key. The available bases are displayed. The selected base to which your handset is
registered has a check mark on its right side.
7. Select a base by using the
then the LCD window displays the ID of the base unit.
8. Press the OK soft key.
9. Enter 9234, the Authentication Code, which is preset at factory, then press the OK soft key.
10. When the registration is properly completed, the handset returns to the Standby mode and displays the
base number and the handset number.
11. Unplug the power cord and then plug it in again.
Notes:
¥ If you have registered the handset to several bases, and the base number you select at step 7 is already used
for another base, you will be asked to confirm that you want to overwrite. If you press the Yes soft key, the
old information is cleared and the base number will be used for your newly selected base. To keep old
information, press and hold the
number.
¥ The time limit for registering a handset to a base is 60 seconds. The registration will be automatically
cancelled when this time has elapsed.
¥ If you fail to register the handset, the handset displays Fail to Register.
2-35
soft key, then press the Select soft key. Please wait appears for a short time,
C key to cancel the setting, then start over again with a different base
Operations & Installation