Registering New Handset With Base - Samsung SPR-5200 Service Manual

2-33 Registering New Handset with Base

Up to six handsets can be registered and operated from your base unit. The system allows you to make internal
calls between two handsets while a third is making an call.
The supplied handset with the base unit is already registered as handset 1. Each additional handset you
purchase must be registered to the base unit.
2-33-1 To Register a Handset
1. Press or button repeatedly until
2. Enter the PIN code, then press
3. Press or button repeatedly to choose the base number you want to specify for the base.
4. Press and hold the button on the base unit for more than 3 seconds until the lamp on the base unit blinks.
5. Press button on the handset.
OK
Result: appears for a short time, then the LCD window displays the ID of the base unit.
6. Press button.
OK
Note: Do not press
ID will be shown in the display. To exit, press and hold C/R button, then start over again.
7. Enter 9234, the Authentication Code, which is preset at factory.
Result : When the registration is properly completed, the LCD window displays the base number on the
right corner and the handset number on the left corner of the
display.
8. Press button.
OK
Note: If you have registered the handset to several bases, and the base number you select at step 3 is already
used for another base,
and the base number will be newly used for your newly selected base. To keep old information, press
and hold C/R button to cancel the setting, then start over again with a different base number.
2-27
button.
OK
or If there is another base which is accidentally ready to accept the handset, the base
warning appears. If you press
appears in the display, then press
OK
button.
OK
Press the button to
access registration
mode.
button, the old information is cleared
Operations & Installation