Set Type Code - ABB DCS800 Service Manual

Set type code

The type code - TypeCode (97.01) - is preset in the factory and is write protected.
It identifies the drives current-, voltage-, temperature measurement and its
quadrant type. The type code can be changed as whole or individually.
To change the type code as whole follow the instructions below:

un-protect the type code by means of ServiceMode (99.06) = SetTypeCode

set TypeCode (97.01) = S01-0020-04 to S02-5200-05 (details, see table
below)
The drive's basic type code: DCS800-AAX-YYYY-ZZB
Product family:
Type:
Bridge type:
Module type:
Rated AC Voltage:
Power connection:
Attention:
When using D1, D2, D3 or D4 modules the current and voltage range of the type
code setting is limited to max 1000 ADC and max 600 VAC.

the change of the type code is immediately taken over and ServiceMode
(99.06) is automatically set back to NormalMode

the new values can be seen in group 4
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DCS800
AA
X
YYYY
ZZ
B
ConvNomCur (4.05),
ConvNomVolt (4.04),
MaxBridgeTemp (4.17) and
QuadrantType (4.15)
3ADW000195R0501 DCS800 Service Manual e e
= S0 Modules
= R0 Rebuild system
= E0 Panel solution
= A0 Enclosed converter
= 1 single bridge (2-Q)
= 2 2 anti parallel bridges (4-Q)
= converter type current
= 04 230 VAC - 400 VAC
= 05 230 VAC - 525 VAC
= 06 270 VAC - 600 VAC
= 07 315 VAC - 700 VAC
= 08 360 VAC - 800 VAC
= 10 450 VAC - 990 VAC
= 12 540 VAC - 1200 VAC
= - Standard D1 - D6
= L Left side D7
= R Right side D7
= a Second thyristor type D5, D6
131
Service