Programming Cable Converter Control; To Unlock The Cable Key; To Program The Cable Key - Universal Electronics MillenNium 4 User Manual

PROGRaMMinG Cable COnVeRTeR
The Millennium 4 is preprogrammed at the fac-
tory to operate the cable converter given to you by
your cable company. However, if you have another
brand or model of cable converter or satellite
receiver that you would like to control, then you'll
need to perform the following instructions to
unlock the cable key, enter in a new code, and lock
the cable key again.

To unlock the Cable key:

1. Turn on the Cable Converter.
2. On the Millennium 4, press Cbl once.
Press and hold seTuP until the LED
blinks twice, then release seTuP.
3. Enter 9 - 8-2. The LED will blink four
times.

To program the Cable key:

1. Locate the brand name of your Cable
Converter section starting on the next
page, and write it in the appropriate space.
Cable Converter Brand: ______________
The brands are listed in alphabetical
order with the most popular codes listed
first. You will use one of these codes to
reprogram the Millennium 4 to operate
your Cable Converter or DBS Receiver.
2. On the Millennium 4, press Cbl once.
Press and hold seTuP until the LED
blinks twice, then release seTuP.
3. Enter the first four-digit code for your
Cable Converter. If you perform this
procedure correctly, the LED will blink
twice.
NOTE: If the LED did not blink twice after
entering the code's last digit, then repeat steps 2
through 3 and try entering the same code again.
4. Aim the Millennium 4 at your Cable
Converter and press POWeR once.
The unit should turn off. If it does not
30