Installing Batteries; Programming Device Control - Universal Electronics Potenza ST User Manual

Nebula Potenza ST.fm Page 9 Monday, October 15, 2007 4:55 PM

INSTALLING BATTERIES

1. On the back of the remote control, push the
tab and lift off the battery cover.
2. Locate the two (2) enclosed AA batteries.
Match the + and - marks with those in the
battery case, then insert them.
3. Align the covers keys with the cases holes and
press the cover back into place. The tab should
click when the cover is locked.
4. Test the remote control by pressing any mode
key (e.g., TV). If the batteries are inserted
correctly, the LED (red light) will blink once.
NOTE: When batteries need replacement, the remote
control will cease to operate. Replace the
batteries and the unit will be restored to its
full functionality, complete with your favorite
settings.

PROGRAMMING DEVICE CONTROL

The Potenza ST Universal Remote Control is
preprogrammed to operate the set-top box provided by
your television service provider, an RCA TV, a Toshiba
DVD player, an RCA VCR, and a Pioneer audio receiver.
To control devices other than the default brands,
perform the following steps; otherwise skip this section.
www.urcsupport.com
9
1
2
3