Wheel Motor Service - Toro Reelmaster 3100-D Service Manual

Wheel Motor Service

3
2
1
1. Dirt seal
2. Bearing
3. Housing
4. Back- -up washer
5. Seal rings
6. Back- -up washer
7. Inner seal
8. Thrust washer
9. Thrust bearing
10. Bearing
NOTE: The three wheel motors used on the Reelmas-
ter 3100--D are similar in construction but do have some
differences. The right front and left front motors are the
same basic design but the right side motor has a reverse
timed manifold to allow correct rotation direction for for-
ward and reverse. The end cover of the rear motor has
a check valve consisting of a ball and spring, and both
front motors lack this feature. The wheel motor shown
in Figure 45 is a rear motor.
IMPORTANT: If a wheel motor failure occurred, refer
to Traction Circuit (Closed Loop) Component Fail-
ure in the General Information section for informa-
tion regarding the importance of removing
contamination from the traction circuit.
Hydraulic System
10
8
9
8
7
6
5
4
Figure 45
11. Coupling shaft
12. Thrust bearing
13. Drive link
14. Cap screw
15. Commutator seal
16. Commutator
17. Woodruff key
18. Wear plate
19. Rotor
Page 4 - - 70
13
12
11
16
17
22
21
20
19
18
20. Vane
21. Stator
22. Manifold
23. Commutator ring
24. End cover
25. Ball
26. Spring
27. Plug
28. O- -ring
NOTE: Machines
260999999 use a Ross Torqmotor
tions. Machines with serial numbers above 270000000
use a Ross Torqmotor
motors in the front positions. For repair of Ross wheel
TM
motors, see the Ross Torqmotor
Series Service Procedure at the end of this chapter. For
repair of Parker wheel motors, see the Parker Torqmo-
tor Service Procedure (TC, TB, TE, TJ, TF, TG, TH
TM
and TL Series) at the end of this chapter.
14
15
24
28
27
23
with serial numbers
in all three posi-
TM
in the rear and two Parker Torq-
TM
MG, MF, ME, and MJ
TM
Reelmaster 3100--D
27
28
26
25
below