Table of Contents
Advertisement
Operating Instructions
Installer:
This product has been manu-
factured and 100% quality tested.
Safety Warnings
L Disconnect the power supply
before attempting any work
on the sensor!
L Before installation, make sure
that power has been switched
off at the breaker and check
that the circuit is dead with
a voltage tester.
Assembly/Installation
For indoor use only.
Sensor and load modules come
preassembled and must be sepa-
rated for access to the commis-
sioning settings on the backside
of sensor module by opening the
locking tabs k on the sides.
System Components
a
Load module
b
Sensor module
c
Sensor control plate
d
Sensor DIP switch settings
(1) Normal / Test mode
(2) Manual 'ON' / Automatic
'ON' mode
(3) Momentary / Maintained
switch option
(4) 'ON' only / 'ON'&'OFF'
manual switching
(5) Constant light level DIM
control option
(6)(7)(8)
Trigger mode
(DT Quattro only)
Please read all of the instructions
before installation. This will help
you to be familiarized with all the
features and options available to
you with these devices.
L Installing the sensor involves
work on the line voltage power
supply. This work must there-
fore be carried out profession-
ally in accordance with the
applicable Nation Electrical
Codes and electrical operating
conditions.
(see chart on page 2)
l
Reconnect and seat the sensor
to the load module and secure
the locking tabs k for normal
operation.
e
Light level setting
f
Occupancy time
delay setting
Switching output 1
g
HVAC stay-'ON' time
Switching output 2
h
HVAC switch-'ON' delay
Switching output 2
i
Reach setting
1 0
COM1-24 Wiring
.1
1 0
COM2-24 Wiring
.2
1 0
COM2-24 Multiple Sensor
.3
Wiring
- 6 -
This will also assist you to mini-
mize installation time and provide
maximum energy savings and
trouble-free operation.
L Control output DIM-24
(1-10 V) must only be used
for connecting electronic
ballasts with an electrically
isolated 10V dimming
control input.
Accessories:
- WGC Wire Guard Cage
- RC 3 Service Remote
- RC 4 User Remote
1 0
DIM-24 Wiring
.4
1 0
DIM-24 Multiple Sensor
.5
Wiring
k
Locking mechanism
l
Assembly / Installation /
Dimensional Drawings
m
Stay 'ON' time DIM before
'OFF' option
n
Trigger mode options
Advertisement
Table of Contents
