Installation; Notes On Installation; Storage; Transport - Siemens Sitrans FX300 Operating Instructions Manual

SITRANS FX300

3.1 Notes on installation

INFORMATION!
Inspect the cartons carefully for damage or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Check the packing list to check if you received completely all that you ordered.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.

3.2 Storage

• Store the device in a dry and dust-free location.
• Avoid extended direct exposure to the sun.
• Store the device in its original packing.
• The permissible storage temperature for standard devices is -40...+80°C / -40...+176°F.

3.3 Transport

• Use lifting straps wrapped around both process connections for transport.
• Do not lift measuring devices by the signal converter housing for transport.
• Never lift the measuring device by the pressure sensor.
• Do not use lifting chains as they may damage the housing.
Figure 3-1: Transport instructions
CAUTION!
Non-secured devices can pose risk of injury. The centre of mass of the device is often higher
than the point at which the lifting straps are attached.
Prevent the measuring device from sliding or rotating accidentally.
06/2009 - SFIDK.PS.050.F2.02 A5E02100423 www.siemens.com/flow

INSTALLATION

3
17