3.9 GRASS-CATCHER ASSEMBLY
A) Join the upper part of the frame (1)
to the front component (2) using the
supplied screws and nuts (3) as
shown. Fit the two rubber caps (4) into
the holes in the tube of front frame (2).
HF2•••HT•
B) Before fully tightening the nuts
(3), insert the two supports (5) be-
tween the plates of the upper frame
(1) with the rollers turned inwards.
Fasten them with the screws and
nuts (6) and then fully tighten the
nuts (3).
C-D) Attach the two side elements
(7), using the screws and nuts (8 and
9) as shown. Fit the two rubber caps
(10) into the holes in the two side ele-
ments (7).
E) Insert the frame in the canvas cover
(11) making sure it is correctly posi-
tioned on the base perimeter. Hook the
plastic profiles (12) onto the frame
tubes with the aid of a screw-driver
(13).
HF2•••SB•
HF2•••HM•
F) Place the plate (14) between the
canvas and the lower part of the
frameʼs right side element (7a), lin-
ing up the holes.
EN
6