Ecu Driver Builder - Aim Solo 2 DL User Manual

A page for adding some useful information appears.
It may be useful to know that:
n "Short Track Name" is the name you will see on your device.
n "Circuit type" and "Road surface", even if not necessary to set the track, are used by
the research filters.
It is possible to change the start line position (move the cursor and set
"Cursor Position") and to add split points, in order to organize the track in different
segments. This will be used in Data Analysis.
Press "Save" and the new track will appear in the list labelled "User".
Since the software is constantly updated, may be other information or features will
be available soon. Please check our website www.aim-sportline.com documentation
area software section "Track Manager" manual.
52
CHAPTER 7

7.5 ECU Driver builder

If your vehicle ECU is not included in Race Studio 3 software you can use CAN Driver
builder to create your own CAN protocol. Press CAN Protocols button shown here
above and then "New". The panel shown below appears.
You can add a new ECU Manufacturer and/or a new ECU model.
Please note: this Race Studio function is for expert users only and a CAN Driver
builder user manual can be freely downloaded from AiM website at
www.aim-sportline.com, documentation area software/firmware section.
SOLO 2 DL
53