Lcu One Can Setting; Parameters Settings - Aim Solo 2 DL User Manual

7.2.3 LCU-One CAN setting
Solo 2 DL can be connected to AiM LCU One CAN lambda controller plugging the 5
pins male Binder connector of LCU one in the female one bottom left of Solo 2 DL.
Once the expansion connected you need to set it:
n enter "LCU-One CAN" tab
n press "ADD" button; it switches to "Remove"
n name your LCU One and fill in its serial number or press "Get SN from a connected
expansion" to receive the serial number from the connected LCU-One
n select the multiplier to calculate AFR from lambda (in the example"14.57 Gasoline")
n set the LCU One channels double clicking on each channel and setting the panel or add a custom value pressing "Add Custom Value"
that shows up
40
CHAPTER 7

7.2.4 Parameters settings

Parameters page is divided in two parts.
n on top GPS Lap detection parameters; mousing over the question marks a pop-up
message will explain you the working mode of: n hold lap time for: the time period for which lap time is shown on your
n the track width: width that will be considered for any GPS point you set Solo 2 DL display
n bottom Start data recording conditions;
n standard conditions (default setting) make Solo 2 DL start recording when
n custom conditions: you can set two conditions and decide if making RPM is higher than 500 or speed is higher than 10 km/h
Solo 2 DL start recording when only one of them is reached ("ANY") or when
both are satisfied ("ALL"); pressing the button it sets the condition as shown
here below.
SOLO 2 DL
41