Motor drive controller interface board-microchip dsp (13 pages)
Summary of Contents for EPC EPC9041
Page 1
Development Board EPC9041 Quick Start Guide EPC2105 Monolithic Half-Bridge with Gate Drive Revision 1.0...
Page 2
** Maximum current depends on die temperature – actual maximum current with be subject to switching frequency, bus datasheet available from EPC at www.epc-co.com. The datasheet should voltage and thermal cooling. Symmetrical eGaN intended for 50% duty cycle or low step-down ratio applications.
THERMAL CONSIDERATIONS of heat-sinking and forced air cooling can significantly increase the The EPC9041 development boards showcase the EPC2105 eGaNIC. current rating of these devices, but care must be taken to not exceed These development boards are intended for bench evaluation the absolute maximum die temperature of 150°C.
Page 4
Optional CON4 Zero 1:4 HB SW OUT µf, 100 V NC7SZ08L6X SDM03U40 R20 Zero CON4 Zero PWM2 Optional µf, 25 V LM5113TM 100pF SDM03U40 CON1 Optional Optional 100 pF CON4 Zero Keystone 5015 CON4 Figure 4: EPC9041 Development Board Schematic...
Page 5
Disclaimer: EPC reserves the right at any time, without notice, to make changes to any products described herein to improve reliability, function, or design. EPC does not assume any liability arising out of...
Need help?
Do you have a question about the EPC9041 and is the answer not in the manual?
Questions and answers