Related Manuals for EPC EPC9514
Summary of Contents for EPC EPC9514
- Page 1 Demonstration System EPC9514 Quick Start Guide 6.78 MHz, 27 W, 19 V Regulated Wireless Power Receiver using EPC2016C Revision 1.0...
-
Page 2: Detailed Description
= 8.3 V 1.4* Unreg_min circuit is attached to the coil. A photo of the EPC9514 is shown in figure 1. * Actual maximum current subject to operation temperature limits. For more information on the EPC2016C eGaN FETs, please refer to the datasheet available from EPC at www.epc-co.com. -
Page 3: Quick Start Procedure
In this mode, the regulator is used to provide a fixed output voltage of 19 V The EPC9514 can be operated with or without the regulator. The regulator for the wireless power receiver and will limit the output current to 1.4 A. -
Page 4: Measurement Notes
Demonstration Board EPC9514 MEASUREMENT NOTES 3. Never connect the EPC9514 device board into your VNA in an attempt to When measuring the high frequency content such as the switch-node, measure the input impedance. Doing so can severely damage the VNA. - Page 5 Boost Controller Texas Instruments LM3481MM/NOPB Gate Driver with LDO Texas Instruments UCC27611DRV Table 3: Optional Components Item Reference Part Description Footprint 100 V 5 A Diode PowerDI5 / SMB | EPC – EFFICIENT POWER CONVERSION CORPORATION | WWW.EPC-CO.COM | COPYRIGHT 2018...
- Page 6 22 m 0.4 W 84.5 k 1% R 41 set to 19 V 6.04 k Ground Post 100 pF, 25 V 30 V 500 mA ST PS0530Z 1 µF, 25 V 100 nF, 16 V Output Voltage Set Figure 4: EPC9514 Receiver schematic.
- Page 7 Demonstration Board Warning and Disclaimer The EPC9514 board is intended for product evaluation purposes only and is not intended for commercial use. Replace components on the Evaluation Board only with those parts shown on the parts list (or Bill of Materials) in the Quick Start Guide. Contact an authorized EPC representative with any questions.
Need help?
Do you have a question about the EPC9514 and is the answer not in the manual?
Questions and answers