Power Backup Feature - Uniden ELT 560 SERIES Owner's Manual

Multi-handset phone
Hide thumbs Also See for ELT 560 SERIES:
Table of Contents

Advertisement

UP742.book Page 8 Tuesday, November 30, 2004 2:42 PM

Power Backup Feature

note
The phone uses the power backup feature to provide power backup for a power
failure or outage.
appears if the
Install the power backup battery in the base
battery pack is not
installed in the base.
•To use power backup
1) Open the battery case cover by pressing the release button on
feature, you need to
the bottom of the base as shown.
connect the AC adapter
2) Plug the battery connector (red and black wires) into the jack
to the base, and
charge the base
inside the battery compartment. (The connector notches fit into
battery at least for 24
the grooves of the jack only one way). Match the wire colors to
hours.
the polarity label in the battery compartment, connect the
•To make or receive a
battery and listen for a click to insure connection.
call, you must connect
3) Make sure you have a good connection by gently pulling on the
the AC adapter when
setting up the phone.
battery wires. If the connection is secure, the battery jack will
remain in place.
4) Place the battery case cover back on the base.
5) Align the tabs on the cover with the grooves on the base, and
press down the cover until it clicks into place.
w w w . u n i d e n . c o m
S e t t i n g u p t h e P ho n e [ 8 ]

Advertisement

Table of Contents
loading

Table of Contents