Agilent Technologies Cary 8454 Installation Manual page 28

2 Installation and Start Up
Installing your UV-Visible Spectrophotometer
3 Plug the female end of the power cord into the power input socket at
Installing the Waste Tubing
There is a waste outlet for the sample area. It is used to drain any liquids
which may come from the sample area in case of a leak or a spill to a
waste container. To connect your waste tubing to the spectrophotometer:
1 Lift the front part of the spectrophotometer up so that you can locate
Figure 4
2 Connect the waste tubing which comes with your spectrophotometer to
3 Put the other end of the waste tubing into the waste container.
4 Make sure that the waste tubing has a constant down slope from the
28
switch is off, see Figure
the rear of the spectrophotometer. Plug the male end of the power cord
into your electrical outlet.
the waste outlet underneath the sample pan.
Connecting the waste tubing
the waste outlet underneath the sample pan.
spectrophotometer to the waste container.
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
1.